PPY series
- Used with cold and warm tap water.
- Made of polypropylene yarn.
- Special design allows for gradient adsorption of contaminants thus prolonging the effective life of the cartridge.
- Low pressure drop with large flow rates.
- Designed specifically to filter mechanical contaminants like sand, silt and rust with size up to 1, 5, 20, 50 microns.
- Made of ANSI/NSF/FDA approved materials
- Core made of high grade polypropylene
- Working temperature 1oC - 52oC.
- Capacity without flushing - 3 to 5 months*
* Depending on water quality and level of contaminants.
Tested at: 6 atm, 15oC, nominal flow rate. |
 |
PPY series filter cartridges are available in combination of the length, diameter and micron rate as the following listed table. it will fit most standard filter housings. Standard filter lengths and special sizes are available. Cartridges are individually shrunk wrapped and labeled. Purimate sediment filters have the micron rating embossed on the side of every cartridge for easy identification.
Technical specification
Cartridge Length: |
4-7/8”, 9-3/4”(248mm), 9-7/8”(251mm), 10”(254mm);
19-1/2” (495mm), 20” (508mm);
29-1/4” (743mm), 30’(762mm), 40” (1016mm) |
Inner diameter |
1-1/8”(F28mm),1-1/4”(F30mm) |
Outer diameter |
2-7/8”(F64mm), 4-1/2”(F115mm) |
Nominal micron rates |
1mm, 5mm, 10mm, 20mm, 50mm. |
Working temperature: |
1°C - 52°C. |
Mainly Application:
Drinking water, Reverse Osmosis System, Food and Beverages, Hotels, Housing Complexes, General Commercial and Industrial Filtration
Notes:
Purimate PPY (polypropylene yarn) filter are designed for sediment removal from potable water. These filters will not remove all cysts, bacteria or viruses. Combined with other super purifier or Purimate UV sterilizer as the combination water purifier system are recommended. |
Products
Cartridge>> Sediment>>PPY Series 
浙ICP备05037372号